ASTM D5093-02(2008)

    Standard Test Method for Field Measurement of Infiltration Rate Using Double-Ring Infiltrometer with Sealed-Inner Ring


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    1. Scope

    1.1 This test method describes a procedure for measuring the infiltration rate of water through in-place soils using a double-ring infiltrometer with a sealed inner ring.

    1.2 This test method is useful for soils with infiltration rates in the range of 1 × 107 m/s to 1 × 1010 m/s. When infiltration rates 1 × 107 m/s are to be measured Test Method D 3385 shall be used.

    1.3 All observed and calculated values shall conform to the guide for significant digits and rounding established in Practice D 6026.

    1.3.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

    1.4 This test method provides a direct measurement of infiltration rate, not hydraulic conductivity. Although the units of infiltration rate and hydraulic conductivity are similar, there is a distinct difference between these two quantities. They cannot be directly related unless the hydraulic boundary conditions, such as hydraulic gradient and the extent of lateral flow of water are known or can be reliably estimated.

    1.5 This test method can be used for natural soil deposits, recompacted soil layers, and amended soils such as soil bentonite and soil lime mixtures.

    1.6 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.

    1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D3385 Test Method for Infiltration Rate of Soils in Field Using Double-Ring Infiltrometer

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D6026 Practice for Using Significant Digits in Geotechnical Data


    ICS Code

    ICS Number Code 65.060.35 (Irrigation and drainage equipment)

    UNSPSC Code

    UNSPSC Code 11111800(Clays)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D5093-02R08

    Citation Format

    ASTM D5093-02(2008), Standard Test Method for Field Measurement of Infiltration Rate Using Double-Ring Infiltrometer with Sealed-Inner Ring, ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top