ASTM D473-02(2006)

    Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of sediment in crude oils and fuel oils by extraction with toluene. The precision applies to a range of sediment levels from 0.01 to 0.40 % mass, although higher levels may be determined. Note 1Precision on recycled oils and crank case oils is unknown and additional testing is required to determine that precision.

    <>

    1.2 &si-value;

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 6.1.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D4057

    D4177

    D5854 Practice for Mixing and Handling of Liquid Samples of Petroleum and Petroleum Products (API MPMS Chapter 8.3)

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications


    ICS Code

    ICS Number Code 75.040 (Crude petroleum); 75.160.20 (Liquid fuels)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0473-02R06

    Citation Format

    ASTM D473-02(2006), Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top