SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|16||$67.00||  ADD TO CART|
1.1 This guide addresses procedures that may be used for obtaining soil samples from the vadose zone (unsaturated zone). Samples can be collected for a variety of reasons including the following:
1.1.1 Stratigraphic description,
1.1.2 Hydraulic conductivity testing,
1.1.3 Moisture content measurement,
1.1.4 Moisture release curve construction,
1.1.5 Geotechnical testing,
1.1.6 Soil gas analyses,
1.1.7 Microorganism extraction, or
1.1.8 Pore liquid and soils chemical analyses.
1.2 This guide focuses on methods that provide soil samples for chemical analyses of the soil or contained liquids or contaminants. However, comments on how methods may be modified for other objectives are included.
1.3 This guide does not describe sampling methods for lithified deposits and rocks (for example, sandstone, shale, tuff, granite).
1.4 In general, it is prudent to perform all field work with at least two people present. This increases safety and facilitates efficient data collection.
1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D653 Terminology Relating to Soil, Rock, and Contained Fluids
D1452 Practice for Soil Exploration and Sampling by Auger Borings
D1586 Test Method for Penetration Test (SPT) and Split-Barrel Sampling of Soils
D1587 Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes
D2488 Practice for Description and Identification of Soils (Visual-Manual Procedure)
D3550 Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils
D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
D4220 Practices for Preserving and Transporting Soil Samples
D5434 Guide for Field Logging of Subsurface Explorations of Soil and Rock
D6151 Practice for Using Hollow-Stem Augers for Geotechnical Exploration and Soil Sampling
D6169 Guide for Selection of Soil and Rock Sampling Devices Used With Drill Rigs for Environmental Investigations
D6282 Guide for Direct Push Soil Sampling for Environmental Site Characterizations
D6286 Guide for Selection of Drilling Methods for Environmental Site Characterization
D6519 Practice for Sampling of Soil Using the Hydraulically Operated Stationary Piston Sampler
D6640 Practice for Collection and Handling of Soils Obtained in Core Barrel Samplers for Environmental Investigations
D6907 Practice for Sampling Soils and Contaminated Media with Hand-Operated Bucket Augers
D6914 Practice for Sonic Drilling for Site Characterization and the Installation of Subsurface Monitoring Devices
ICS Number Code 07.060 (Geology. Meteorology. Hydrology)
UNSPSC Code 11111501(Soil)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D4700-91(1998)e1, Standard Guide for Soil Sampling from the Vadose Zone, ASTM International, West Conshohocken, PA, 1991, www.astm.orgBack to Top