Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D4683-96

Standard Test Method for Measuring Viscosity at High Shear Rate and High Temperature by Tapered Bearing Simulator

Standard Test Method for Measuring Viscosity at High Shear Rate and High Temperature by Tapered Bearing Simulator D4683-96 ASTM|D4683-96|en-US Standard Test Method for Measuring Viscosity at High Shear Rate and High Temperature by Tapered Bearing Simulator Standard new BOS Vol. 05.02 Committee D02
$ 75.00 In stock

Scope

1.1 This test method covers the laboratory determination of the viscosity of engine oils at 150°C and 1 X 10 s -1 shear rate using a tapered bearing simulator-viscometer (TBS Viscometer) equipped with a refined thermoregulator system. Older TBS units not so equipped must use Test Method D4683-87.

1.2 The Newtonian calibration oils used to establish this test method cover the range from approximately 1.5 to 5.6 cP (mPa[dot]s) at 150°C.

1.3 The non-Newtonian reference oil used to establish this test method has a viscosity of approximately 3.5 cP (mPa[dot]s) at 150°C and a shear rate of 1 X 10 s -1 .

1.4 Applicability to petroleum products other than engine oils has not been determined in preparing this test method.

1.5 This test method uses the centipoise (cP) as the unit of viscosity. For information on the equivalent SI unit, the millipascal second (mPa[dot]s) is shown in parentheses.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.02
Developed by Subcommittee: D02.07
Pages: 6
DOI: 10.1520/D4683-96
ICS Code: 75.100