ASTM D452-91(2008)

    Standard Test Method for Sieve Analysis of Surfacing for Asphalt Roofing Products

      Format Pages Price  
    PDF 2 $52.00   ADD TO CART

    1. Scope

    1.1 This test method covers the determination of the particle size distribution of surfacing material, other than mineral granules, such as sand, mica, talc, or other powdered or flaky mineral particles, used on both sides of smooth roll roofing and on the reverse side of asphalt shingles and mineral-surfaced roll roofing.

    1.2 The values stated in SI units are to be regarded as standard. The values in parentheses are mathematical conversions to inch-pound units that are provide for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    ICS Code

    ICS Number Code 91.100.15 (Mineral materials and products)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt); 30151500(Roofing materials)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0452-91R08

    Citation Format

    ASTM D452-91(2008), Standard Test Method for Sieve Analysis of Surfacing for Asphalt Roofing Products, ASTM International, West Conshohocken, PA, 2008,

    Back to Top