ASTM D4436-84(1998)

    Standard Test Method for Rock Bolt Long-Term Load Retention Test


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 The objective of this test method is to determine the time over which rock bolt tension decreases from the installed value to a designated minimum value.

    1.2 This test method is applicable to any anchor system which is not fully encapsulated immediately upon installation, including mechanical, cement grout, resin (epoxy, polyester, and the like) or other similar systems.

    1.3 The values stated in inch-pound units are to be regarded as the standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D4435 Test Method for Rock Bolt Anchor Pull Test

    D6026 Practice for Using Significant Digits in Geotechnical Data


    ICS Code

    ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)

    UNSPSC Code

    UNSPSC Code 31161632(Rock bolt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D4436-84R98

    Citation Format

    ASTM D4436-84(1998), Standard Test Method for Rock Bolt Long-Term Load Retention Test, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top