ASTM D429-02a

    Standard Test Methods for Rubber Property—Adhesion to Rigid Substrates

      Format Pages Price  
    PDF 20 $67.00   ADD TO CART

    1. Scope

    1.1 These test methods cover procedures for testing the static adhesional strength of rubber to rigid materials (in most cases metals).

    Method A—Rubber Part Assembled Between Two Parallel Metal Plates.

    Method B—90 Stripping Test-Rubber Part Assembled to One Metal Plate.

    Method C—Measuring Adhesion of Rubber to Metal with a Conical Specimen.

    Method D—Adhesion Test-Post-Vulcanization (PV) Bonding of Rubber to Metal.

    Method E—90 Stripping Test-Rubber Tank Lining-Assembled to One Metal Plate.

    Method FRubber Part Assembled Between Two Parallel Convex-Shaped Metal Plates

    Method G-Measuring Bond Durability for Rubber-to-Metal Bonded Components with a Double Shear Cylindrical Specimen

    1.2 While the test method may be used with a wide variety of rigid materials, use of materials other than metals is the exception. For this reason, we have used the word "metal" in the text rather than "rigid materials."

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B117 Practice for Operating Salt Spray (Fog) Apparatus

    D395 Test Methods for Rubber Property--Compression Set

    D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

    D471 Test Method for Rubber Property--Effect of Liquids

    D572 Test Method for Rubber--Deterioration by Heat and Oxygen

    D573 Test Method for Rubber--Deterioration in an Air Oven

    D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

    E4 Practices for Force Verification of Testing Machines

    G153 Practice for Operating Enclosed Carbon Arc Light Apparatus for Exposure of Nonmetallic Materials

    ICS Code

    ICS Number Code 83.060 (Rubber)

    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0429-02A

    Citation Format

    ASTM D429-02a, Standard Test Methods for Rubber Property—Adhesion to Rigid Substrates, ASTM International, West Conshohocken, PA, 2002,

    Back to Top