ASTM D413-98(2002)e1

    Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the determination of the adhesion strength between plies of fabric bonded with rubber or the adhesion of the rubber layer in articles made from rubber attached to other material. They are applicable only when the adhered surfaces are approximately plane or uniformly circular as in belting, hose, tire carcasses, or rubber-covered sheet metal.

    1.2 When the adhered surfaces contain sharp bends, angles, or other gross irregularities that cannot be avoided in preparing test specimens, special test methods must be employed for evaluating adhesion.

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D3040 Practice for Preparing Precision Statements for Standards Related to Rubber and Rubber Testing

    D3182 Practice for RubberMaterials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets

    D3183 Practice for RubberPreparation of Pieces for Test Purposes from Products


    ICS Code

    ICS Number Code 83.060 (Rubber)

    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0413-98R02E01

    Citation Format

    ASTM D413-98(2002)e1, Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top