Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D412-98a(2002)e1

Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension

Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension D0412-98AR02E01 ASTM|D0412-98AR02E01|en-US Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension Standard new BOS Vol. 09.01 Committee D11
$ 83.00 In stock

Scope

1.1 These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:

Test Method A—Dumbbell and Straight Section Specimens
Test Method B—Cut Ring Specimens

Note 1—These two different methods do not produce identical results.

1.2 The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D11.10
Pages: 14
DOI: 10.1520/D0412-98AR02E01
ICS Code: 83.060