Standard Historical Last Updated: Apr 14, 2017 Track Document
ASTM D3588-98(2011)

Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels D3588-98R11 ASTM|D3588-98R11|en-US Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels Standard new BOS Vol. 05.06 Committee D03
$ 75.00 In stock

Significance and Use

The heating value is a measure of the suitability of a pure gas or a gas mixture for use as a fuel; it indicates the amount of energy that can be obtained as heat by burning a unit of gas. For use as heating agents, the relative merits of gases from different sources and having different compositions can be compared readily on the basis of their heating values. Therefore, the heating value is used as a parameter for determining the price of gas in custody transfer. It is also an essential factor in calculating the efficiencies of energy conversion devices such as gas-fired turbines. The heating values of a gas depend not only upon the temperature and pressure, but also upon the degree of saturation with water vapor. However, some calorimetric methods for measuring heating values are based upon the gas being saturated with water at the specified conditions.

The relative density (specific gravity) of a gas quantifies the density of the gas as compared with that of air under the same conditions.

Scope

1.1 This practice covers procedures for calculating heating value, relative density, and compressibility factor at base conditions (14.696 psia and 60°F (15.6°C)) for natural gas mixtures from compositional analysis. It applies to all common types of utility gaseous fuels, for example, dry natural gas, reformed gas, oil gas (both high and low Btu), propane-air, carbureted water gas, coke oven gas, and retort coal gas, for which suitable methods of analysis as described in Section 6 are available. Calculation procedures for other base conditions are given.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.06
Developed by Subcommittee: D03.03
Pages: 9
DOI: 10.1520/D3588-98R11
ICS Code: 75.160.30