ASTM D352-97

    Standard Test Methods for Pasted Mica Used in Electrical Insulation


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the testing of bonded mica splittings and bonded mica paper to be used for commutator insulation, hot molding, heater plates, and other similar insulating purposes.

    1.2 These test methods appear in the following sections:

    Test Sections Compressive Creep 4 to 10 Dielectric Strength 38 to 41 Mica or Binder Content 19 Molding Test 31 to 37 Organic Binder 20 to 24 Resistivity 42 to 46 Silicone Binder 25 to 30 Stability Under Heat and Pressure 11 to 18

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Notes 3 and 5 and 38.1 and 43.1 for specific hazard statements.

    1.4 The values stated in inch-pound units are to be regarded as the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

    D257 Test Methods for DC Resistance or Conductance of Insulating Materials

    D1711 Terminology Relating to Electrical Insulation


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0352-97

    Citation Format

    ASTM D352-97, Standard Test Methods for Pasted Mica Used in Electrical Insulation, ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top