ASTM D3282-09

    Standard Practice for Classification of Soils and Soil-Aggregate Mixtures for Highway Construction Purposes


      Format Pages Price  
    PDF 7 $60.00   ADD TO CART


    1. Scope

    1.1 This practice covers a procedure for classifying mineral and organomineral soils into seven groups based on laboratory determination of particle-size distribution, liquid limit, and plasticity index. It may be used when a precise engineering classification is required, especially for highway construction purposes. Evaluation of soils within each group is made by means of a group index, which is a value calculated from an empirical formula.

    Note 1—The group classification, including the group index, should be useful in determining the relative quality of the soil material for use in earthwork structures, particularly embankments, subgrades, subbases, and bases. However, for the detailed design of important structures, additional data concerning strength or performance characteristics of the soil under field conditions will usually be required.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 This practice offers a set of instructions for performing one or more specific operations. This practice cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this practice may be applicable in all circumstances. This practice is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this practice be applied without consideration of a project's many unique aspects. The word Standard in the title of this document means only that the document has been approved through the ASTM consensus process.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D421 Practice for Dry Preparation of Soil Samples for Particle-Size Analysis and Determination of Soil Constants

    D422 Test Method for Particle-Size Analysis of Soils

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D1140 Test Methods for Determining the Amount of Material Finer than 75-m (No. 200) Sieve in Soils by Washing

    D1452 Practice for Soil Exploration and Sampling by Auger Borings

    D1586 Test Method for Penetration Test (SPT) and Split-Barrel Sampling of Soils

    D1587 Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D4318 Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils

    D4700 Guide for Soil Sampling from the Vadose Zone

    D6913 Test Methods for Particle-Size Distribution (Gradation) of Soils Using Sieve Analysis

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    AASHTO Document

    M145


    ICS Code

    ICS Number Code 93.080.10 (Road construction)

    UNSPSC Code

    UNSPSC Code 11111501(Soil)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3282-09

    Citation Format

    ASTM D3282-09, Standard Practice for Classification of Soils and Soil-Aggregate Mixtures for Highway Construction Purposes, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top