Standard Historical Last Updated: Jul 13, 2011 Track Document
ASTM D3246-05

Standard Test Method for Sulfur in Petroleum Gas by Oxidative Microcoulometry

Standard Test Method for Sulfur in Petroleum Gas by Oxidative Microcoulometry D3246-05 ASTM|D3246-05|en-US Standard Test Method for Sulfur in Petroleum Gas by Oxidative Microcoulometry Standard new BOS Vol. 05.01 Committee D02
$ 75.00 In stock

Significance and Use

Trace quantities of sulfur compounds in hydrocarbon products can be harmful to many catalytic chemical processes in which these products are used. Maximum permissible levels of total sulfur are normally included in specifications for such hydrocarbons. It is recommended that this test method be used to provide a basis for agreement between two laboratories when the determination of sulfur in hydrocarbon gases is important.

On liquefied petroleum gas, total volatile sulfur is measured on an injected gas sample. For such material a liquid sample must be used to measure total sulfur.

Scope

1.1 This test method covers determination of sulfur in the range from 1.5 to 100 mg/kg (ppm by mass) by weight in hydrocarbon products that are gaseous at normal room temperature and pressure.

Note 1— The test method has been tested cooperatively only on high-purity ethylene gas. Precision data have not been developed for other products.

1.2 The values stated in Si units are to be regarded as the standard. The values given n parentheses are for information only

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.01
Developed by Subcommittee: D02.03
Pages: 8
DOI: 10.1520/D3246-05
ICS Code: 75.080