ASTM D3213-13e1

    Standard Practices for Handling, Storing, and Preparing Soft Intact Marine Soil


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 These practices cover methods for project/cruise reporting, and handling, transporting and storing soft cohesive intact marine soil. Procedures for preparing soil specimens for triaxial strength, and consolidation testing are also presented.

    1.2 These practices may include the handling and transporting of sediment specimens contaminated with hazardous materials and samples subject to quarantine regulations.

    1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

    1.4 These practices offer a set of instructions for performing one or more specific operations. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of these practices may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project’s many unique aspects. The word “Standard” in the title means only that the document has been approved through the ASTM consensus process.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Sections 1, 2 and 7.

    1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D1587/D1587M Practice for Thin-Walled Tube Sampling of Fine-Grained Soils for Geotechnical Purposes

    D2435/D2435M Test Methods for One-Dimensional Consolidation Properties of Soils Using Incremental Loading

    D2488 Practice for Description and Identification of Soils (Visual-Manual Procedures)

    D2850 Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D4186/D4186M Test Method for One-Dimensional Consolidation Properties of Saturated Cohesive Soils Using Controlled-Strain Loading

    D4220/D4220M Practices for Preserving and Transporting Soil Samples

    D4452 Practice for X-Ray Radiography of Soil Samples

    D4648/D4648M Test Methods for Laboratory Miniature Vane Shear Test for SaturatedFine-Grained Clayey Soil

    D8121/D8121M Test Method for Approximating the Shear Strength of Cohesive Soils by the Handheld Vane Shear Device


    ICS Code

    ICS Number Code 07.060 (Geology. Meteorology. Hydrology)

    UNSPSC Code

    UNSPSC Code 11111501(Soil)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3213-13E01

    Citation Format

    ASTM D3213-13e1, Standard Practices for Handling, Storing, and Preparing Soft Intact Marine Soil, ASTM International, West Conshohocken, PA, 2013, www.astm.org

    Back to Top