SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$52.00||  ADD TO CART|
1.1 This test method covers measurement of the comparative tack of pressure-sensitive adhesives by a rolling ball and is most appropriate for low-tack adhesives. This test method is only one of several available for the measurement of tack.
1.1.1 This test method is not recommended for the specification of end use products.
1.2 Values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system must be used independently without combining values in any way.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D907 Terminology of Adhesives
D5750/D5750M Guide for Width and Length of Pressure-Sensitive Tape
E171 Practice for Conditioning and Testing Flexible Barrier Packaging
ICS Number Code 83.180 (Adhesives)
UNSPSC Code 31201626(Pressure sensitive adhesive PSA)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D3121-06, Standard Test Method for Tack of Pressure-Sensitive Adhesives by Rolling Ball (Withdrawn 2015), ASTM International, West Conshohocken, PA, 2006, www.astm.orgBack to Top