ASTM D312-00

    Standard Specification for Asphalt Used in Roofing


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This specification covers four types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The specification is intended for general classification purposes only, and does not imply restrictions on the slope at which an asphalt must be used (see Appendix X1).

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D5 Test Method for Penetration of Bituminous Materials

    D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

    D92 Test Method for Flash and Fire Points by Cleveland Open Cup Tester

    D113 Test Method for Ductility of Bituminous Materials

    D140 Practice for Sampling Bituminous Materials

    D1079 Terminology Relating to Roofing and Waterproofing

    D2042 Test Method for Solubility of Asphalt Materials in Trichloroethylene

    D3461 Test Method for Softening Point of Asphalt and Pitch (Mettler Cup-and-Ball Method)


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt); 30151500(Roofing materials)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0312-00

    Citation Format

    ASTM D312-00, Standard Specification for Asphalt Used in Roofing, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top