ASTM D3115-95(2009)

    Standard Test Method for Explosive Reactivity of Lubricants with Aerospace Alloys Under High Shear


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This test method is used to evaluate for explosive reactivity of various lubricants in the presence of aerospace alloys under high shear conditions.

    1.2 The values stated in SI units are to be regarded as the standard. In cases where materials, products, or equipment are available in inch-pound units only, SI units are omitted.

    1.3 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate

    B221 Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes

    ANSI Standard

    B46.1 Surface Texture Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.


    ICS Code

    ICS Number Code 49.025.99 (Other materials)

    UNSPSC Code

    UNSPSC Code 15120000(Lubricants and oils and greases and anti)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3115-95R09

    Citation Format

    ASTM D3115-95(2009), Standard Test Method for Explosive Reactivity of Lubricants with Aerospace Alloys Under High Shear, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top