SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$60.00||  ADD TO CART|
1.1 This test method describes the application of two procedures for the determination of the property of coke of withstanding breakage when dropped under specified test conditions.
1.2 Procedure A , is used when the coke sample contains 50% or less of 100 mm (4 in.) after removal of coke smaller than 50 mm (2 in.). Procedure A appears in Sections 6, 7, 8 and 9.
1.3 Procedure B , is used when the coke sample contains more than 50% 100 mm (4 in.) after removal of coke smaller than 50 mm (2 in.). Procedure B appears in Sections 10, 11, 12 and 13.
1.4 The values stated in SI units shall be regarded as standard. Inch-pound units shall be accepted on an equivalent basis.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D121 Terminology of Coal and Coke
D293 Test Method for the Sieve Analysis of Coke
D346 Practice for Collection and Preparation of Coke Samples for Laboratory Analysis
D4621 Guide for Quality Management in an Organization That Samples or Tests Coal and Coke
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
E323 Specification for Perforated-Plate Sieves for Testing Purposes
ICS Number Code 75.160.10 (Solid fuels)
UNSPSC Code 15101604(Coke)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D3038-93(1999), Standard Test Method for Drop Shatter Test for Coke, ASTM International, West Conshohocken, PA, 1999, www.astm.orgBack to Top