ASTM D3018/D3018M-11

    Standard Specification for Class A Asphalt Shingles Surfaced with Mineral Granules


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This specification covers granule-surfaced asphalt roofing shingles that meet the requirements for Class A fire test, behavior on heating, and wind testing.

    1.2 Shingles meeting this specification are intended to be applied with a headlap of not less than 51 mm [2 in.].

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D228/D228M Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing

    D1079 Terminology Relating to Roofing and Waterproofing

    D3161/D3161M Test Method for Wind-Resistance of Steep Slope Roofing Products (Fan-Induced Method)

    E108 Test Methods for Fire Tests of Roof Coverings


    ICS Code

    ICS Number Code 91.100.15 (Mineral materials and products)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt); 30151508(Shingles)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D3018_D3018M-11

    Citation Format

    ASTM D3018 / D3018M-11, Standard Specification for Class A Asphalt Shingles Surfaced with Mineral Granules, ASTM International, West Conshohocken, PA, 2011, www.astm.org

    Back to Top