ASTM D2985-92(2002)e1

    Standard Test Method for Color of Asbestos


      Format Pages Price  
    PDF 9 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of color, whiteness, and yellowness of asbestos by means of a photoelectric reflectometer.

    1.2 The test method is applicable to all grades and varieties of homogeneous milled asbestos.

    1.3 This test method may be applied to samples that are not dry or homogeneous, or that contain impurities or adulterants. However, in such cases, results may not be comparable with those obtained on clean dry samples.

    1.4 To obtain similar results from spectrophotometers, see Test Method E 308.

    1.5 The values stated in SI (metric) units are to be regarded as standard. The inch-pound (customary) units are for information only.

    1.6 Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysotile asbestos, refer to "Safe Use of Chrysotile: A Manual of Preventive and Control Measures."

    1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates

    D2590 Test Method for Sampling Chrysotile Asbestos

    D2946 Terminology for Asbestos and Asbestos-Cement Products

    D3879 Test Method for Sampling Amphibole Asbestos

    E3 Guide for Preparation of Metallographic Specimens

    E259 Practice for Preparation of Pressed Powder White Reflectance Factor Transfer Standards for Hemispherical and Bi-Directional Geometries

    E308 Practice for Computing the Colors of Objects by Using the CIE System


    ICS Code

    ICS Number Code 17.180.20 (Colours and measurement of light)

    UNSPSC Code

    UNSPSC Code 41110000(Measuring and observing and testing instruments); 11101510(Asbestos)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2985-92R02E01

    Citation Format

    ASTM D2985-92(2002)e1, Standard Test Method for Color of Asbestos, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top