ASTM D297-93(1998)

    Standard Test Methods for Rubber Products-Chemical Analysis


      Format Pages Price  
    PDF 37 $86.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the qualitative and quantitative analysis of the composition of rubber products of the "R" family (see 3.1). Many of these test methods may be applied to the analysis of natural and synthetic crude rubbers.

    1.1.1 Part A consists of general test methods for use in the determination of some or all of the major constituents of a rubber product.

    1.1.2 Part B covers the determination of specific polymers present in a rubber product.

    1.1.3 The test methods appear in the following order:

    Part A. General Test Methods: Sections Rubber Polymer Content by the Indirect Method 11 to 13 Determinations and Report for the General Method 14 and 15 Density 16 Extract Analysis 17 to 26 Sulfur Analysis 27 to 33 Fillers Analysis 34 to 40 Ash Analysis 41 to 51 Part B. Determination of Rubber Polymers 52 to 58

    1.4 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

    1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 31.6, 37.4.2, Notes 7, 9, 13, 18, 20, and 22; and X1.3.3 and X2.4.1.6.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D982 Test Method for Organic Nitrogen in Paper and Paperboard

    D1416 Test Methods for Rubber from Synthetic Sources--Chemical Analysis

    D1418 Practice for Rubber and Rubber Latices--Nomenclature

    D1646 Test Methods for Rubber--Viscosity, Stress Relaxation, and Pre-Vulcanization Characteristics (Mooney Viscometer)

    D3040 Practice for Preparing Precision Statements for Standards Related to Rubber and Rubber Testing

    D3156 Practice for Rubber--Chromatographic Analysis of Antidegradants (Antioxidants, Antiozonants and Stabilizers)

    D3452 Practice for Rubber--Identification by Pyrolysis-Gas Chromatography

    D3677 Test Methods for Rubber--Identification by Infrared Spectrophotometry

    D4483 Practice for Evaluating Precision for Test Method Standards in the Rubber and Carbon Black Manufacturing Industries

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    E131 Terminology Relating to Molecular Spectroscopy

    E200 Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis

    E442 Test Method for Chlorine, Bromine, or Iodine in Organic Compounds by Oxygen Flask Combustion

    E443 Test Method for Sulfur in Organic Compounds by Oxygen Flask Combustion


    UNSPSC Code

    UNSPSC Code 13101607(Rubber compound)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0297-93R98

    Citation Format

    ASTM D297-93(1998), Standard Test Methods for Rubber Products-Chemical Analysis, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top