Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D2940-03

Standard Specification for Graded Aggregate Material For Bases or Subbases for Highways or Airports

Standard Specification for Graded Aggregate Material For Bases or Subbases for Highways or Airports D2940-03 ASTM|D2940-03|en-US Standard Specification for Graded Aggregate Material For Bases or Subbases for Highways or Airports Standard new BOS Vol. 04.03 Committee D04
$ 66.00 In stock

Abstract

This specification covers quality-controlled graded aggregates that, when hauled to and properly spread and compacted on a prepared grade to appropriate density standards, may be expected to provide adequate stability and load support for use as highway or airport bases or subbases. Coarse aggregate retained on the sieve shall consist of durable particles of crushed stone, gravel, or slag capable of withstanding the effects of handling, spreading, and compacting without degradation productive of deleterious fines. Fine aggregate passing through the sieve shall normally consist of fines from the operation of crushing the coarse aggregate. Where available and suitable, addition of natural sand or finer mineral matter, or both, is not prohibited. The following tests shall be performed: grain-size test (dry and wet sieving), liquid limit test, plastic limit test, plasticity index test, sand equivalent value test, and expansion test.

Scope

1.1 This specification covers quality-controlled graded aggregates that, when hauled to and properly spread and compacted on a prepared grade to appropriate density standards, may be expected to provide adequate stability and load support for use as highway or airport bases or subbases.

Note 1— The engineer is cautioned to provide appropriate construction specifications to ensure compaction to an extent that further densification from traffic loadings on the completed pavement will be insignificant. The method suggested is to require compaction on a firm foundation of a short control strip of the material at a suitable moisture content, by means of vibratory or other proven effective rollers or tampers, until no further increase in density results. Compaction requirements should ensure that an average density of certain appropriate percentages of the control strip maximum density be achieved on the balance of the job; for base courses, 98% is suggested as the minimum average requirement.

1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units, shown in parentheses, are for information only.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: D04.50
Pages: 2
DOI: 10.1520/D2940-03
ICS Code: 93.080.10; 93.120