ASTM D2925-95(2000)e1

    Standard Test Method for Beam Deflection of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow

      Format Pages Price  
    PDF 4 $52.00   ADD TO CART

    1. Scope

    1.1 This test method covers measurement of the deflection as a function of time of a specimen of fiberglass pipe supported on a flat non-arced support as a simple beam under full bore flow of water at elevated temperatures. Both glass-fiber-reinforced thermosetting-resin pipe (RTRP) and glass-fiber-reinforced polymer mortar pipe (RPMP) are fiberglass pipes.

    Note 1—For the purposes of this standard, polymer does not include natural polymers.

    1.2 This test method can be used to determine deflection at varying conditions by substituting other test media.

    1.3 Deflections observed using this test method are representative only of piping supported as a simple beam under full bore flow which has one diameter of pipe overhanging at each support.

    1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.

    Note 1—There is no or equivalent ISO standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C33/C33M Specification for Concrete Aggregates

    D883 Terminology Relating to Plastics

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

    F412 Terminology Relating to Plastic Piping Systems

    ICS Code

    ICS Number Code 23.040.20 (Plastic pipes)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2925-95R00E01

    Citation Format

    ASTM D2925-95(2000)e1, Standard Test Method for Beam Deflection of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow, ASTM International, West Conshohocken, PA, 2001,

    Back to Top