ASTM D2852-95(2002)

    Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART


    1. Scope

    1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, impact resistance, load-deflection properties, dimensional stability, and joint tightness of plain-end or bell-end styrene-rubber (SR) plastic drain pipe and fittings in sizes 2 through 6 in.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D256 Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics

    D618 Practice for Conditioning Plastics for Testing

    D638 Test Method for Tensile Properties of Plastics

    D648 Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

    D2321 Practice for Underground Installation of Thermoplastic Pipe for Sewers and Other Gravity-Flow Applications

    D2412 Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading

    D2444 Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)

    D3122 Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings

    F412 Terminology Relating to Plastic Piping Systems

    Military Standard

    MIL-STD-129 Marking for Shipment and Storage


    ICS Code

    ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

    UNSPSC Code

    UNSPSC Code 40171517(Commercial PVC pipe)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2852-95R02

    Citation Format

    ASTM D2852-95(2002), Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings, ASTM International, West Conshohocken, PA, 1995, www.astm.org

    Back to Top