ASTM D2835-89(1998)

    Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement. For changes to this Standard since the last issue, refer to the Summary of Changes Section at the end of the Standard.

    1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency and drying rate.

    1.3 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S customary units may be approximate.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1084 Test Methods for Viscosity of Adhesives

    D1644 Test Methods for Nonvolatile Content of Varnishes


    ICS Code

    ICS Number Code 93.080.10 (Road construction)

    UNSPSC Code

    UNSPSC Code 30111500(Concrete and mortars); 31410000(Seals)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2835-89R98

    Citation Format

    ASTM D2835-89(1998), Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top