SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$60.00||  ADD TO CART|
1.1 This practice is a guide for removing test specimens from existing built-up roofing systems in the field and for determining the approximate quantities of the components of that specimen (Note 1). Components determined may be:
1.1.1 Insulation components when they are part of the roof membrane system,
1.1.2 Plies of roofing felt,
1.1.3 Interply layers of bituminous material,
1.1.4 Top coating, and
1.1.5 Surfacing. Note 1 - This procedure is for the investigation of existing roofs and is not intended for new construction inspection.
1.2 This practice is applicable to both 914-mm (36-in.) and 1000-mm (39 3/8-in.) wide felt rolls.
1.3 The values stated in SI (metric) units are to be regarded as standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D226 Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing
D227 Specification for Coal-Tar-Saturated Organic Felt Used in Roofing and Waterproofing
D249 Specification for Asphalt Roll Roofing (Organic Felt) Surfaced with Mineral Granules
D250 Standard Specification for Asphalt-Saturated Asbestos Felt Used in Roofing and Waterproofing
D371 Specification for Asphalt Roll Roofing (Organic Felt) Surfaced with Mineral Granules; Wide Selvage
D1079 Terminology Relating to Roofing and Waterproofing
D2178 Specification for Asphalt Glass Felt Used in Roofing and Waterproofing
D2626 Specification for Asphalt-Saturated and Coated Organic Felt Base Sheet Used in Roofing
D3158 Specification for Asphalt Saturated and Coated Organic Felt Used in Roofing
D3617 Practice for Sampling and Analysis of Built-Up Roof Systems During Application
D3672 Standard Specification for Venting Asphalt-Saturated and Coated Inorganic Felt Base Sheet Used in Roofing
D3909 Specification for Asphalt Roll Roofing (Glass Felt) Surfaced With Mineral Granules
D4601 Specification for Asphalt-Coated Glass Fiber Base Sheet Used in Roofing
D4897 Specification for Asphalt-Coated Glass-Fiber Venting Base Sheet Used in Roofing
D4990 Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing
ICS Number Code 91.100.50 (Binders. Sealing materials)
UNSPSC Code 30151500(Roofing materials); 30121500(Bituminous derivatives)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2829-07, Standard Practice for Sampling and Analysis of Existing Built-Up Roof Systems, ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top