ASTM D2714-94(2003)

    Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the calibration and operation of a block-on-ring friction and wear testing machine.

    1.2 The values stated in either SI (metric) units or inch-pound units to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. Combining values of the two systems may result in noncomformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 19.060 (Mechanical testing)

    UNSPSC Code

    UNSPSC Code 15121500(Lubricating preparations)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2714-94R03

    Citation Format

    ASTM D2714-94(2003), Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine, ASTM International, West Conshohocken, PA, 2003, www.astm.org

    Back to Top