ASTM D2647-94

    Standard Specification for Crosslinkable Ethylene Plastics

      Format Pages Price  
    PDF 3 $52.00   ADD TO CART

    1. Scope

    1.1 This specification covers a general classification system for crosslinkable ethylene plastics compounds (Note 1). The requirements specified herein are not necessarily applicable for use as criteria in determining suitability for the end use of a fabricated product.

    Note 1--It is to be noted that this specification describes materials that are available commercially in their uncrosslinked form. Therefore, they are crosslinkable compounds despite the fact that measurement of the parameters used for their classification and specification will usually be carried out after curing has been effected.

    1.2 Two types of compounds are covered, namely, mechanical types in which mechanical strength properties are of prime importance in applications, and electrical types in which electrical insulating or conducting properties also are of prime importance in applications.

    1.3 The parameters used to classify and specify the mechanical types are ultimate elongation, elongation retention after aging, apparent modulus of rigidity, and brittleness temperature.

    1.4 The parameters used to classify and specify the electrical types are ultimate elongation, elongation retention after aging, apparent modulus of rigidity, brittleness temperature, dielectric constant, dissipation factor, and volume resistivity.

    1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.6 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 2--There is no similiar or equivalent ISO standard.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

    D257 Test Methods for DC Resistance or Conductance of Insulating Materials

    D573 Test Method for RubberDeterioration in an Air Oven

    D618 Practice for Conditioning Plastics for Testing

    D638 Test Method for Tensile Properties of Plastics

    D746 Test Method for Brittleness Temperature of Plastics and Elastomers by Impact

    D883 Terminology Relating to Plastics

    D991 Test Method for Rubber Property--Volume Resistivity Of Electrically Conductive and Antistatic Products

    D1043 Test Method for Stiffness Properties of Plastics as a Function of Temperature by Means of a Torsion Test

    D2765 Test Methods for Determination of Gel Content and Swell Ratio of Crosslinked Ethylene Plastics

    D3892 Practice for Packaging/Packing of Plastics

    Military Standard

    MIL-STD-105 Sampling Procedures and Tables for Inspection by Attributes Available from Defense Automation and Production Service, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.(Obsolete 1995)

    UNSPSC Code

    UNSPSC Code 13111016(Polyethylene)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2647-94

    Citation Format

    ASTM D2647-94, Standard Specification for Crosslinkable Ethylene Plastics, ASTM International, West Conshohocken, PA, 2000,

    Back to Top