ASTM D2578-04a

    Standard Test Method for Wetting Tension of Polyethylene and Polypropylene Films


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the measurement of the wetting tension of a polyethylene or polypropylene film surface in contact with drops of specific test solutions in the presence of air.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section 8.

    Note 1—This test method is equivalent to ISO 8296.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D618 Practice for Conditioning Plastics for Testing

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    ISO Standard

    ISO 8296 PlasticsFilm and SheetingDetermination of Wetting Tension Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.


    UNSPSC Code

    UNSPSC Code 13111201(Polyethylene films); 13111211(Polypropylene films)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2578-04A

    Citation Format

    ASTM D2578-04a, Standard Test Method for Wetting Tension of Polyethylene and Polypropylene Films, ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top