SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|8||$60.00||  ADD TO CART|
1.1 This test method covers the field vane test in saturated clay and silt soils for determination of undrained shear strength. Knowledge of the nature of the soil in which each vane test is to be made is necessary for assessment of the applicability and interpretation of the test. The test is not applicable for sandy soils which may allow drainage during the test.
1.2 This test method addresses testing on land and for testing in drill holes or by self drilling or continuous push methods from the ground surface. This method does not address specifically marine testing where special test requirements or variations in equipment may be required. The user is referred to ASTM STP 1014 for additional information on in-place vane shear testing.
1.3 This method is often used in conjunction with fluid rotary drilling (D 5783) or hollow-stem augers (D 6151). Some apparatuses have the vane retracted in protective shoe for advancement and incremental testing. Sampling, such as with thin wall tubes (D 1587) is often combined with vane testing. Subsurface geotechnical explorations are reported in accordance with practice (D 5434).
1.4 Undrained shear strength and sensitivity of cohesive soils can also be measured in Unconfined Compression D 2166 and Laboratory Vane Test (D 4648).
1.5 The values stated in SI units are to be regarded as the standard. English (Imperial) units are given in parentheses.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D653 Terminology Relating to Soil, Rock, and Contained Fluids
D1587 Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes
D2166 Test Method for Unconfined Compressive Strength of Cohesive Soil
D2488 Practice for Description and Identification of Soils (Visual-Manual Procedure)
D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction
D4648 Test Method for Laboratory Miniature Vane Shear Test for SaturatedFine-Grained Clayey Soil
D5434 Guide for Field Logging of Subsurface Explorations of Soil and Rock
D5783 Guide for Use of Direct Rotary Drilling with Water-Based Drilling Fluid for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices
D6151 Practice for Using Hollow-Stem Augers for Geotechnical Exploration and Soil Sampling
Other StandardsEuroCode 7: Geotechnical Design–Part 3 Desi ENV 1997-3:1999E, CEN
ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)
UNSPSC Code 11111501(Soil)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2573-01(2007), Standard Test Method for Field Vane Shear Test in Cohesive Soil, ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top