ASTM D2511-93(2009)

    Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the measurement of the resistance of dry solid film lubricants to deterioration when subjected to temperature extremes.

    1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    U.S. Federal Specification

    P-D-680 Dry Cleaning Solvent Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098.

    ASTM Standards

    A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip

    D2510 Test Method for Adhesion of Solid Film Lubricants

    D4175 Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants


    ICS Code

    ICS Number Code 75.100 (Lubricants, industrial oils and related products)

    UNSPSC Code

    UNSPSC Code 15121500(Lubricating preparations)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2511-93R09

    Citation Format

    ASTM D2511-93(2009), Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top