ASTM D2489/D2489M-08

    Standard Practice for Estimating Degree of Particle Coating of Bituminous-Aggregate Mixtures


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This practice provides an estimate of the degree of particle coating in a bituminous-aggregate mixture on the basis of the percentage of coarse particles classified as being completely coated.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D8 Terminology Relating to Materials for Roads and Pavements

    D979 Practice for Sampling Bituminous Paving Mixtures

    D995 Specification for Mixing Plants for Hot-Mixed, Hot-Laid Bituminous Paving Mixtures

    D3665 Practice for Random Sampling of Construction Materials

    D4215 Specification for Cold-Mixed, Cold-Laid Bituminous Paving Mixtures

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials); 93.080.20 (Road construction materials)

    UNSPSC Code

    UNSPSC Code 30111800(Aggregates); 30121601(Asphalt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2489_D2489M-08

    Citation Format

    ASTM D2489 / D2489M-08, Standard Practice for Estimating Degree of Particle Coating of Bituminous-Aggregate Mixtures, ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top