ASTM D2449-88(1995)e1

    Standard Specification for Rubber Bales From Natural Sources—Limit on Coating

      Format Pages Price  
    PDF 2 $52.00   ADD TO CART

    1. Scope

    1.1 This specification covers bale coating on bales of natural rubber (that have rubber wrapper sheets on the bales) and includes test method description. It specifies the maximum permissible amount of such coating.

    1.2 This specification is not applicable to natural rubber that is packaged with plastic wrappers, as no bale coating is used.

    1.3 The following safety hazards caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1278 Test Methods for Rubber from Natural SourcesChemical Analysis

    D1485 Practice for Rubber from Natural SourcesSampling and Sample Preparation

    UNSPSC Code

    UNSPSC Code 13101500(Natural rubber)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2449-88R95E01

    Citation Format

    ASTM D2449-88(1995)e1, Standard Specification for Rubber Bales From Natural Sources—Limit on Coating, ASTM International, West Conshohocken, PA, 1988,

    Back to Top