ASTM D2421-95

    Standard Practice for Interconversion of Analysis of C5 and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Weight Basis


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART

    Active (view current version of standard)

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More D02.H0 Standards Related Products


    1. Scope

    1.1 This practice describes the procedure for the interconversion of the analysis of C 5 and lighter hydrocarbon mixtures to gas-volume (mole), liquid-volume, or weight in vacuum basis.

    1.2 The computation procedures described assume that gas-volume percentages have already been corrected for nonideality of the components as a part of the analytical process by which they have been obtained. These are numerically the same as mole percentages.

    1.3 The procedure assumes the absence of nonadditivity corrections for mixtures of the pure liquid compounds. This is approximately true only for mixtures of hydrocarbons of the same number of carbon atoms, and in the absence of diolefins and acetylenic compounds.

    1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 75.080 (Petroleum products in general)

    UNSPSC Code

    UNSPSC Code 15111500(Gaseous fuels)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2421-95

    Citation Format

    ASTM D2421-95, Standard Practice for Interconversion of Analysis of C5 and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Weight Basis, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top