ASTM D2294-96

    Standard Test Method for Creep Properties of Adhesives in Shear by Tension Loading (Metal-to-Metal)



    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This test method covers the determination of the creep properties of adhesives for bonding metals when tested on a standard specimen and subjected to certain conditions of temperature and tensile stress in a spring-loaded testing apparatus.

    1.2 This test method is applicable to the temperature range from -55 to +260°C (-67 to +500°F).

    1.3 the values stated in SI units are to be regarded as standard. The inch-pound units in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D638 Test Method for Tensile Properties of Plastics

    D907 Terminology of Adhesives

    D1002 Test Method for Apparent Shear Strength of Single-Lap-Joint Adhesively Bonded Metal Specimens by Tension Loading (Metal-to-Metal)


    UNSPSC Code

    UNSPSC Code 31201600(Other adhesives and sealants)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2294-96

    Citation Format

    ASTM D2294-96, Standard Test Method for Creep Properties of Adhesives in Shear by Tension Loading (Metal-to-Metal), ASTM International, West Conshohocken, PA, 1996, www.astm.org

    Back to Top