ASTM D2281-10

    Standard Test Method for Evaluation of Wetting Agents by the Skein Test


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This test method , covers the determination of the efficiency of ordinary commercial wetting agents as defined in Terminology D459. This test method is applicable under limited and controlled conditions, but does not necessarily yield information correlating with specific end uses.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D459 Terminology Relating to Soaps and Other Detergents


    ICS Code

    ICS Number Code 71.100.40 (Surface active agents)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2281-10

    Citation Format

    ASTM D2281-10, Standard Test Method for Evaluation of Wetting Agents by the Skein Test, ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top