SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$62.00||  ADD TO CART|
1.1 This test method covers the determination of the dropping point of lubricating grease.
1.2 This test method uses mercury thermometers. WARNING—Mercury has been designated by many regulatory agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA’s website—http://www.epa.gov/mercury/faq.htm—for additional information. Users should be aware that selling mercury and/or mercury containing products into your state or country may be prohibited by law. The responsible subcommittee, D02.G0.03, continues to explore alternatives to eventually replace the mercury thermometers.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D217 Test Methods for Cone Penetration of Lubricating Grease
D566 Test Method for Dropping Point of Lubricating Grease
D3244 Practice for Utilization of Test Data to Determine Conformance with Specifications
E1 Specification for ASTMLiquid-in-Glass Thermometers
ISO StandardsISO 2176 Petroleum productsLubricating greaseDetermination of dropping point
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
UNSPSC Code 15121902(Grease)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D2265-19, Standard Test Method for Dropping Point of Lubricating Grease Over Wide Temperature Range, ASTM International, West Conshohocken, PA, 2019, www.astm.orgBack to Top