ASTM D2203-93

    Standard Test Method for Staining from Sealants


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers a laboratory procedure for determining whether a sample of sealant will cause staining of the substrate when in the contact with masonry, concrete, or stone (marble, limestone, sandstone, granite, etc.).

    1.2 The values stated in SI (metric) units are to be regarded as the standard. The values given in parentheses are provided for information only.

    1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1--Currently there is no ISO standard similar to this test method.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C510 Test Method for Staining and Color Change of Single- or Multicomponent Joint Sealants

    C717 Terminology of Building Seals and Sealants


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 31201600(Other adhesives and sealants)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2203-93

    Citation Format

    ASTM D2203-93, Standard Test Method for Staining from Sealants, ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top