ASTM D2194-02(2007)

    Standard Test Method for Concentration of Formaldehyde Solutions


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the formaldehyde content of commercially available formaldehyde solutions ranging in concentration from 36 to 55 weight %.

    1.2 For purposes of determining conformance of an observed value or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

    1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.4 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications


    ICS Code

    ICS Number Code 71.080.80 (Aldehydes and ketones)

    UNSPSC Code

    UNSPSC Code 12352501(Formaldehydes)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2194-02R07

    Citation Format

    ASTM D2194-02(2007), Standard Test Method for Concentration of Formaldehyde Solutions, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top