ASTM D2162-14

    Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards


      Format Pages Price  
    PDF 8 $60.00   ADD TO CART


    1. Scope

    1.1 This practice covers the calibration of master viscometers and viscosity oil standards, both of which may be used to calibrate routine viscometers as described in Test Method D445 and Specifications D446 over the temperature range from 15 °C to 100 °C.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.2.1 The SI-based units for calibration constants and kinematic viscosities are mm2/s2 and mm 2/s, respectively.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D446 Specifications and Operating Instructions for Glass Capillary Kinematic Viscometers

    D1193 Specification for Reagent Water

    D1250 Guide for Use of the Petroleum Measurement Tables

    D1480 Test Method for Density and Relative Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer

    D1590 Test Method for Surface Tension of Water

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E563 Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature

    E644 Test Methods for Testing Industrial Resistance Thermometers

    E1137 Specification for Industrial Platinum Resistance Thermometers

    E1750 Guide for Use of Water Triple Point Cells

    E2593 Guide for Accuracy Verification of Industrial Platinum Resistance Thermometers

    E2877 Guide for Digital Contact Thermometers

    ISO Standard


    ICS Code

    ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2162-14

    Citation Format

    ASTM D2162-14, Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards, ASTM International, West Conshohocken, PA, 2014, www.astm.org

    Back to Top