ASTM D2152-95(2010)

    Standard Test Method for Adequacy of Fusion of Extruded Poly(Vinyl Chloride) (PVC) Pipe and Molded Fittings by Acetone Immersion


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the adequacy of fusion of extruded rigid poly(vinyl chloride) (PVC) pipe and molded fittings as indicated by reaction to immersion in anhydrous acetone.

    1.2 The values stated in inch-pound units are to be regarded as the standard except where instruments are calibrated in SI units.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Annex A1.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D618 Practice for Conditioning Plastics for Testing


    ICS Code

    ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

    UNSPSC Code

    UNSPSC Code 40171517(Commercial PVC pipe)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2152-95R10

    Citation Format

    ASTM D2152-95(2010), Standard Test Method for Adequacy of Fusion of Extruded Poly(Vinyl Chloride) (PVC) Pipe and Molded Fittings by Acetone Immersion, ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top