ASTM D2148-18

    Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART

    Active (view current version of standard)

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More D09.07 Standards Related Products


    1. Scope

    1.1 These test methods cover tests for bondable silicone rubber tapes which form a sealed structure either with the application of heat (and pressure if needed) or by the process of auto-adhesion (self-fusing).

    1.2 The methods appear in the following sections:

    Test Method

    Section

     

     

          Adhesion

    3 – 10

          Bond Strength

    11 – 18

          Dielectric Breakdown Voltage

    19 – 26

          Hardness

    41

          Length

    33 and 34

          Thickness

    27 – 32

          Width

    36 – 40

    1.3 The values stated in inch-pound units are to be regarded as standard, except for °C. The values in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement see 23.1.1.

    1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

    D374/D374M Test Methods for Thickness of Solid Electrical Insulation

    D618 Practice for Conditioning Plastics for Testing

    D1000 Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications

    D1458 Test Methods for Fully Cured Silicone Rubber-Coated Glass Fabric and Tapes for Electrical Insulation

    D2240 Test Method for Rubber PropertyDurometer Hardness


    ICS Code

    ICS Number Code 29.035.20 (Plastic and rubber insulating materials)

    UNSPSC Code

    UNSPSC Code 31201502(Electrical insulating tape)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2148-18

    Citation Format

    ASTM D2148-18, Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation, ASTM International, West Conshohocken, PA, 2018, www.astm.org

    Back to Top