ASTM D2126-09

    Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    D

    1.1 This test method covers procedures for the thermal and humid exposure of rigid cellular plastics. Conditions used shall be agreed upon between the purchaser and the supplier.

    Note 1—A list of commonly used exposure conditions is found in Table 1.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 2—This test method is equivalent to ISO 2796 in the sampling and calculation sections. It is not equivalent to ISO 2796 in the procedure section.

    TABLE 1 Temperature and Relative Humidity Conditions

    Temperature, °C (°F)Relative Humidity, %
    73 ± 3 (100 ± 6)ambient
    40 ± 3 (40 ± 6)ambient
    70 ± 2 (158 ± 4)ambient
    100 ± 2 (212 ± 4)ambient
    150 ± 2 (302 ± 4)ambient
    23 ± 2 (73 ± 4)50 ± 5
    38 ± 2 (100.0 ± 4)97 ± 3
    70 ± 2 (158 ± 4)97 ± 3
    other temperatures and humidities selected for individual needs


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D883 Terminology Relating to Plastics

    D1037 Test Methods for Evaluating Properties of Wood-Base Fiber and Particle Panel Materials

    ISO Standard

    ISO 2796 Cellular Plastics Rigid-Test for Dimensional Stability Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.


    ICS Code

    ICS Number Code 83.100 (Cellular materials)

    UNSPSC Code

    UNSPSC Code 13111300(Foams)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2126-09

    Citation Format

    ASTM D2126-09, Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top