ASTM D2116-02

    Standard Specification for FEP-Fluorocarbon Molding and Extrusion Materials


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART


    1. Scope

    1.1 This specification covers melt processable molding and extrusion materials of FEP-fluorocarbon resin. This specification does not cover recycled FEP materials. These FEP resins are copolymers of tetrafluoroethylene and hexafluoropropylene or modified FEP-fluorocarbon resins containing not more than 2 % by weight of other fluoromonomers.

    1.2 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.

    Note 1—Although this specification and ISO 12086-1 and ISO 12086-2 differ in approach or detail, data obtained using either are technically equivalent.

    1.3 The following precautionary caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

    D618 Practice for Conditioning Plastics for Testing

    D638 Test Method for Tensile Properties of Plastics

    D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

    D883 Terminology Relating to Plastics

    D1238 Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D1708 Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens

    D3892 Practice for Packaging/Packing of Plastics

    D4591 Test Method for Determining Temperatures and Heats of Transitions of Fluoropolymers by Differential Scanning Calorimetry

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    ISO Standards

    ISO12086-1 PlasticsFluoropolymer Dispersions and Moulding and Extrusion MaterialsPart 1

    ISO12086-2


    ICS Code

    ICS Number Code 83.080.20 (Thermoplastic materials); 83.140.99 (Other rubber and plastic products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D2116-02

    Citation Format

    ASTM D2116-02, Standard Specification for FEP-Fluorocarbon Molding and Extrusion Materials, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top