Standard Historical Last Updated: Mar 19, 2014 Track Document
ASTM D2062-03(2009)

Standard Test Methods for Operability of Zippers

Standard Test Methods for Operability of Zippers D2062-03R09 ASTM|D2062-03R09|en-US Standard Test Methods for Operability of Zippers Standard new BOS Vol. 07.01 Committee D13
$ 75.00 In stock

Significance and Use

The significance of specific tests is discussed in the appropriate sections.

These test methods are considered satisfactory for acceptance testing of commercial shipments of zippers because the methods have been used extensively in the trade for this purpose, even though current estimates of between-laboratory precision are quite large in some cases.

If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.

The method(s) in the standard along with those in Test Methods D 2051, D 2052, D 2053, D 2054, D 2057, D 2058, D 2059, D 2060, and D 2061 are a collection of proven test methods. They can be used as aids in the evaluation of zippers without the need for a thorough knowledge of zippers. The enumerated test methods do not provide for the evaluation of all zipper properties. Besides those properties measured by means of the enumerated test methods there are other properties that may be important for the satisfactory performance of a zipper. Test methods for measuring those properties have not been published either because no practical methods have yet been developed or because a valid evaluation of the information resulting from existing unpublished methods requires an intimate and thorough knowledge of zippers.


FIG. 1 Slider Sticking on Bottom Stop

Scope

1.1 These test methods cover procedures for determining the following characteristics of zippers:

Sections
Opening and Closing of Zippers14-17
Separator Functioning of Zippers18-22
Sticking of Zippers at Stops10-13

1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.01
Developed by Subcommittee: D13.54
Pages: 6
DOI: 10.1520/D2062-03R09
ICS Code: 61.040