ASTM D1994-95(2000)

    Standard Test Method for Determination of Acid Numbers of Hot-Melt Adhesives


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of acid numbers of hot-melt adhesives.

    1.2 This test method is applicable for hot-melt and hot-melt/acid systems that are soluble under the conditions described. The hot melt must also give light- or medium-colored solutions when dissolved. If this is not the case another method must be used.

    1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific caution statements are given in Note 1 and Note 2.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D907 Terminology of Adhesives

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 83.180 (Adhesives)

    UNSPSC Code

    UNSPSC Code 31201609(Hot melt adhesives)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1994-95R00

    Citation Format

    ASTM D1994-95(2000), Standard Test Method for Determination of Acid Numbers of Hot-Melt Adhesives, ASTM International, West Conshohocken, PA, 2000, www.astm.org

    Back to Top