ASTM D197-87(2002)

    Standard Test Method for Sampling and Fineness Test of Pulverized Coal

      Format Pages Price  
    PDF 7 $60.00   ADD TO CART

    1. Scope

    1.1 This test method covers the determination of the fineness by sieve analysis of coal sampled from a dry pulverizing operation. It is not applicable to products of wet milling or to fines that have clustered into an agglomerated mass.

    1.2 The values stated in inch-pound units shall be regarded as the standard. Sample weights of 1000 g or less shall be expressed in metric units.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves

    ICS Code

    ICS Number Code 73.040 (Coals)

    UNSPSC Code

    UNSPSC Code 15101601(Coal)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0197-87R02

    Citation Format

    ASTM D197-87(2002), Standard Test Method for Sampling and Fineness Test of Pulverized Coal, ASTM International, West Conshohocken, PA, 1987,

    Back to Top