Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D1896-99(2004)

Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds

Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds D1896-99R04 ASTM|D1896-99R04|en-US Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds Standard new BOS Vol. 08.01 Committee D20
$ 66.00 In stock

Scope

1.1 This practice covers a general procedure for the transfer molding of mechanical and electrical test specimens of thermosetting molding materials.Note 1The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting intermediate viscosity non-Newtonian flow.

1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

There is no similar, or equivalent, ISO standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.09
Pages: 4
DOI: 10.1520/D1896-99R04
ICS Code: 83.140.99