ASTM D1895-96(2003)

    Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the measurement of apparent density, bulk factor, and where applicable, the pourability of plastic materials such as molding powders. Different procedures are given for application to the various forms of these materials that are commonly encountered, from fine powders and granules to large flakes and cut fibers.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1—Test Method A is equivalent to ISO Method R 60 as described in the appendix. Test Method C is identical with ISO Method R 61.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

    D883 Terminology Relating to Plastics

    D1505 Test Method for Density of Plastics by the Density-Gradient Technique

    ISO Standards

    R60 Determination of Apparent Density of Molding Materials that Can be Poured from a Specified Funnel

    R61


    ICS Code

    ICS Number Code 83.080.01 (Plastics in general)

    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1895-96R03

    Citation Format

    ASTM D1895-96(2003), Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials, ASTM International, West Conshohocken, PA, 2003, www.astm.org

    Back to Top