ASTM D1865-89(2002)

    Standard Test Method for Hardness of Mineral Aggregate Used on Built-Up Roofs


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of hardness of all types of mineral surfacing for use on built-up roofs and is intended to provide an index of their ability to withstand physical breakdown in handling.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D75 Practice for Sampling Aggregates

    D451 Test Method for Sieve Analysis of Granular Mineral Surfacing for Asphalt Roofing Products

    E11 Specification for Wire Cloth and Sieves for Testing Purposes


    ICS Code

    ICS Number Code 91.100.15 (Mineral materials and products)

    UNSPSC Code

    UNSPSC Code 30111801(Natural aggregate); 30151500(Roofing materials)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1865-89R02

    Citation Format

    ASTM D1865-89(2002), Standard Test Method for Hardness of Mineral Aggregate Used on Built-Up Roofs, ASTM International, West Conshohocken, PA, 1989, www.astm.org

    Back to Top